![]() Return requests beyond 30 days of receipt will not be honored.Īny shipping fees (including, but not limited to, standard shipping fees, expedited shipping fees, international shipping fees, shipping to HI or AK) are non-refundable. Items that have been installed, used, worn, or modified in any way cannot be returned. All products must be in their original manufacturer packaging, in new condition, and must have all original labels/tags attached to it. For return shipping/restocking fee information please see below.Īll returned merchandise requests must be initiated within 30 days upon receipt of the item. Returns without a valid return authorization will be refused and no credit will be issued. Please contact us via email at or by phone at 80 to obtain return authorization. “It’s like you’re wallpapering a globe,” she says, but she was able to avoid gaping thanks to the overlap.If you need to return a product, our Customer Service professionals are ready to assist you. Butt seams could also cause an opening, especially if the wall is bellying out, or slightly protrudes in one place. Alternatively, you can try matching the edge of each panel, also known as a butt seam, but this application depends on the pattern. According to Hunt, overlapping is a bit more forgiving and gives novice wallpaper installers more wiggle room in terms of pattern match. Step 6: Slightly overlap wallpaper seamsĪs you hang each new wallpaper panel, slightly overlap each new roll over the one already on the wall. “I would caution anyone new to wallpapering about how unforgiving a pattern like plaid can be,” she says. She then drew several horizontal lines, using the grid line of the hanging panel, across the wall, which served as a guide. To fix the problem of crooked panels, Dallery took the level to the original center panel and double-checked it was straight. The wallpaper was only one or two millimeters off at the top of the wall and then at the bottom it was hanging crooked almost an inch to the left.” She took a level to the ceiling and found it slightly slanted. ![]() “I found I could not eyeball it or use the ceiling as a guide. ![]() ![]() “It’s very hard to detect if the roll is straight,” she says. Photos: Marc VaughnĪs Dallery started to hang the second roll, she soon realized that when the two panels connected, the horizontal lines of the wallpaper pattern were no longer matching. Step 5: Check your measurements and level againĭouble check the center panel with a level. Once the wallpaper is cut (slightly past the baseboard, for additional length), you can maneuver the panel into place. After shaking the EZ Hang bottle for about a minute, spray the middle section, and toward the baseboard, but not the baseboard itself since you’ll want adhesion there, too. “You would not want ‘slip’ at that point the wallpaper needs to hold as you pull and peel it down,” Hunt says. Keep in mind that you don’t want to spray it where the ceiling meets the wall. Pro tip: Hunt likes using EZ Hang to allow slight movement and easy lifting for correcting alignment once the peel-and-stick wallpaper is applied. Save the rest of the roll for less visible corner panels you’ll probably have to piece two shorter rolls together. Leave some overhang, cut off excess with scissors. Unroll the wallpaper roll to the bottom of the baseboard, then use smoother to adhere it flush against the surface. Photo: Marc Vaughnīecause the bedroom walls are slightly textured, Dallery found it easier to use her hand to smooth out the wallpaper, and then use the smoother to tackle stubborn air bubbles. Allow for some overhang at the bottom, too.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |